2-1/2" Round. Trailer light with reflector functions as a clearance and side marker light when properly mounted. Durable polycarbonate base and lens. Mounts on surface of trailer - hardware not included. 2-Wire pigtail. PC rated.
Features:
Specs:
A PC-rated light produces a 90-degree angle of light to either side of its centerline for a total of 180 degrees of coverage. This beam pattern can be clearly seen when you are standing directly in front of the light, as well as when you are standing on either side of the light. When properly installed, this type of light can function as both a front clearance light and a side marker light or as a rear clearance light and side marker light.
Surface-mount trailer lights install using a flange or bracket with mounting holes. These lights lay flat against the trailer surface and only require a small, often pre-existing hole, for wiring. Mounting hardware is used to secure the light to the trailer.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today, we're taking a look at a LED clearance or side marker light with a built-in reflex reflector. This round trailer light functions as both a clearance light and a side marker light when properly mounted. It is an LED system. LEDs make great replacements for incandescent lights. They last longer, burn brighter, and they're much more efficient. With LEDs, you don't have to worry about replacing bulbs or worry about brittle filaments.The unit features the really nice amber lens with the built-in reflex reflector.
It mounts on the surface of the trailer. You have three mount holes right there. You can gain access to those by removing the lens from the base. Mounting hardware for installation is not included. It's a two-wire pigtail, so the white wire is the ground wire, yellow wire is the power wire.
Now, the installation surface does require at least a 5/8" diameter hole for the wire base to fit into for a flush mount design. It is SAE approved, and it is a P2PC rated light.Taking a look at the dimensions real quick, starting with the overall diameter. Measuring edge to edge, that gives us a diameter measurement of about 2 1/2". The thickness of the unit, from the back of the base, right here, to the front of the lens, measures about 1" thick or 1" deep. That's how far it sticks out from the installation surface.
The distance we have between each mount hole, center on center, is 1 5/8".We're going to go and hook it up to power. That way you can see what it looks like with some power running to it. We'll also be able to turn off our overhead lights, so you can see it in a lower light setting. You can see here that the light sends out a nice consistent signal. You can see that built-in reflex reflector.
This light features a total of two diodes or two LEDs, so the multi-diode design really helps optimize the overall light output.That's going to do it for today's look at the LED clearance or side marker light with the built-in reflex reflector.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.